Camaro Concept

[canmark]

Starting another one. Still very rough.

[teeworks.]

nice done mate! still there are some inaccuracies especially in the back, but its a good start, definitely. did you use any blueprints? if yes, where did you get them/do you wanna share them with us?

so keep it up!
TeeWorks

[canmark]

Unfortunately I have no prints. I just used reference photos from the web.
I just laid out the mass for the back, now I'll start to refine it.

[canmark]

Tweaking body still lots of bumps

[EquiNOX]

I couldn't believe you got it off references, and it still look almost identical to camaro concept. However work may be messy.... Yup, bumpy and the seam lines has too much spaces on hood, trunk, bumper, and etc. Can you post one in wire?

[canmark]

I'll post some wires after I clean up the back. The gaps are large because I have not chamfered and extruded the panels yet. I'm just going by pictures, however I did use a 69 camaro blueprint to get me started.

[cenkkara]

very good start , keep up

[canmark]

Here's the wires. Still have to narrow the gaps between the panels.

[canmark]

Little more done on back

[Pafi]

I pointed you some bugs I seen (Some of them may be perhaps good, I don't know this car well)
Otherwise, i like it very much ! nice done !

[canmark]

I haven't fixed alot of those areas yet however the back and front do come to a point. Still a long way to go to clean it up.

[X-Ice]

Nice, do you use bluprints?

[XCNuse]

Nice, do you use bluprints?

lol what blueprints would you be referring to?

[canmark]

Used 69 camaro prints to get rough shape