Audi A3

[P2sta]

Hi everyone, I started work on my new car, it Audi A3, I hope, I'll finish it. I began yesterday evening, so here is my first picture, if there is something wrong, please write it

[petter]

looks very good.
just 2 crits:
-that tripach must be repaired
-work on hood's meshflow

[P2sta]

Originally Posted by petter

looks very good.
just 2 crits:
-that tripach must be repaired
-work on hood's meshflow

hi, thanks, the are 4 vertexes, it looks like triangle, but it isnt I will else work with it. What about the hood meshflow?

[petter]

oh.sorry,about the trianlge

the hood mesh flow it's bad.
just move the vertexes with edge constraint, so the polygons become as much as equal possible with eachother

one question:
how do you make the wire on a side and on the other side, it can't be seen?

[P2sta]

Ok, I'll remake it, on all body , here are two other views

[petter]

of course you don't need to redo it. just move the vertexes along the edges

[P2sta]

Originally Posted by petter

of course you don't need to redo it. just move the vertexes along the edges

Yes, I know, my english is bad and I don't know how to write it, so I write easilly remake

[P2sta]

here are some updates, I've made roof and now,it's time to begin cuting

[P2sta]

hi, I need help with this part, there was a 5side poly, so I remake it, and now it looks quiet strange, have someone some better solution?

[zylak]

hi
don't know if it's solve Ur problem, but i think THIS looks better

pozdro & god luck - NICE START M8