Lamborghini Murcielago

[xaoo]

Hello,

I joined this forum some time ago, but this is my first post I was looking on the all works in here and finally I decided to create my car. I am a beginner in 3d world, but I try to do my best. I am modeling Lamborghini Murcielago and so far I finished woks on the front of the car. I attach two files - one render and one viewport screen. It is my second model and I am doing it using a tutorial, but anyway I would like to hear some comments from all of you.

Regards,

xaoo

[rodderworld]

looks like a good start. i drew out some improvements. i didn't do them in all views but i think you can figure my sketch out.

regards,
rodder

[P2sta]

hi, looks like good start, rodder shows you some good advices, keep working

[petter]

Originally Posted by rodderworld

looks like a good start. i drew out some improvements. i didn't do them in all views but i think you can figure my sketch out.

regards,
rodder

you can repair that n-gon and the 3 sided poly near it by simply cutting a line through the middle of the n-gon to the middle segment between n-gon and tri:P

it's even simplyer that it seems :P

[rodderworld]

@petter:i realized that after i posted it. still, mine gives it some nice density.

regards,
rodder

[xaoo]

Hello,

Thank you guys for all your comments and good advice. I will try to adopt those changes soon

Regards,

xaoo

[petter]

Originally Posted by rodderworld

@petter:i realized that after i posted it. still, mine gives it some nice density.

regards,
rodder

that's why the edit button exists:P
there are various sollutions, but the best will be merginng both ideas, yours and mine:P

[rodderworld]

actually petter, i just noticed your solution would still leave a massive tri on the front bumper. but yes, that's why we have the edit button.

regards,
rodder

[xaoo]

Welcome after short break. I have made some small update to the model. I worked on the side of the car. Mainly on the doors and the area under them. I hope you like it

Regards,

xaoo

P.S.

@rodderworld and petter - I modified the place you were talking about. I did it in a slightly different way and I still have 5-gon, but as I looked on the render and this 5-gon has no influence on the mesh.